3/2 Way NO Pneumatic Solenoid Valve G3/8'' 24V DC 0.9-10bar
Image may vary slightly
3/2 way (normally open) pneumatic solenoid valve from Festo with G3/8 inch ports (female thread) and 24 V DC coil. Indirect operated (internally piloted). Applications include controlling a single-acting cylinder. Operating pressure from 0.9 to 10 bar (13 to 145 psi). Only suitable for air. With manual override control. Can be mounted on manifold with central air supply/vent. Response time 0.01 s, Kv-value 120 Nm³/h. (2000 l/min).
The valve plug is not included.
View allDescription
This valve is 3/2 way, normally open, equipped with one coil. The valve has G 3/8 inch ports (BSPP female thread). The coil voltage is 24 V DC and the power is 0.95 VA. The valve can only be operated with compressed air (filtered up to 5 μm) that doesn't need to be lubricated. The operating pressure is 0.9 to 10 bar (13 to 145 psi). Mounting on manifold with a central supply and vent possible. Response time is 0.01s. The valve has a Kv flow rate value is 120 Nm³/h (2000 l/min).. This valve is equipped with a manual override. Never exceed the valve limits (pressure, temperature, voltage, media, etc.). Do not apply any voltage to the coil when the coil is removed from the valve in order to prevent burn-through.
A 3/2-way valve has three ports and two states. It can be used to control a single-acting cylinder, among other applications. The valve's ports and functions are described as follows:.
- Port 1 (Supply Port): This is the port where the compressed air supply connects. It supplies air to the valve.
- Port 2 (Actuator Port): This port connects to the actuator (e.g., a cylinder). It is used to either fill or vent the actuator, depending on the state of the valve.
- Port 3 (Exhaust Port): This port vents the air from the actuator back to the atmosphere.
Pros:
- Low flow resistance Kv-value (120 Nm³/h)
- Fast and reliable operation
- Duty Cycle 100%
- Low energy consumption (0.95VA)
- Maintenance free design
- Coil can be installed in four directions (4 x 90°)
- Designed for manifold mounting
Cons:
- Only for (clean) air, not for other media or vacuum
- Minimal pressure of 0.9 bar required for proper operation (pilot operated valve)
Downloads
Specifications
LEGAL DISCLAIMER
All products are 100% genuine and legally purchased from authorized sources. Indspare is not an authorized dealer, agent or affiliate of any of the designers, brands, or manufacturers, the products of which are offered for sale on www.indspare.com. All trademarks, brand names, and logos mentioned are used for identification purposes only and are registered trademarks of their respective owners who reserve the rights of ownership. The use of trademark, brand name or product on our website is not intended to suggest that the company, trademark or brand is affiliated to or endorses our website.